Mpc hc linux7/29/2023 ![]() ![]() Note, myprofile1 is never loaded because it is never called in the top level area.Īlternatively one could call mpv from the command line with:Īnd it would ignore all options except the ones for myprofile1. When mpv starts it sees the first line, loads the options in myprofile2 (which means it loads the options in gpu-hq and log-file=~~/log) finally it loads ontop=yes and finishes starting up. There are only two lines within the top level area and there are two separate profiles defined below it. Log-file=~~/log #Sets a location for writing a log file, ~~/ translates to ~/.config/mpv ![]() Profile=gpu-hq #A built in profile that comes with mpv Profile-desc="a profile" #Optional description for profile #A simple profile, top level area ends here Profile=myprofile2 #Top level area, load myprofile2 However, once you define a profile by writing its name in brackets then every option you write below it (until you define a new profile) is considered part of that profile. ![]() The area at the top of mpv.conf is called the top level, any options you write there will kick into effect once mpv is started. nest profiles so that you can make more complicated profiles out of simpler ones.Ĭreating a profile is easy.Create special profiles for special content.Quickly switch between different configurations without having to rewrite the file.In mpv.conf it is possible to create profiles which are essentially just "groups of options" with which you can:
0 Comments
Leave a Reply. |